HTC One M8 Audio Testing

Looking at the numbers for the HTC One M8 there are a few things that stand out. The first is the output power of around 1.2 Vrms for all loads. This is a lot of power for a smartphone and should be able to drive almost any set of headphones you would use with it. There is more distortion on the 15 Ohm load but as there are 95 mW at max volume, you should be able to step the volume down a bit and reduce the THD+N.

We also see that crosstalk gets better as we have an easier load to drive. The lower (more negative) the crosstalk is, the less noise is leaking from one channel into the other. This is also the test most subject to error when using the USB automation of the phones. On the HTC One M8, USB testing results in a crosstalk level of -0.01 dB. If you are using your HTC One M8 for music you are best to not have it connected over USB while listening.

  15 Ohm 33 Ohm 150 Ohm 330 Ohm
Dynamic Range 91.791 dB 92.074 dB 91.690 dB 92.008 dB
THD+N 0.3365% 0.0152% 0.0103% 0.0101%
Crosstalk (L) -58.032 dB -64.780 dB -77.688 dB -83.656 dB
Crosstalk (R) -57.950 dB -64.329 dB -77.194 dB -83.240 dB
Output Power 95.55 mW 47.63 mW 11.14 mW 5.116 mW
Output Voltage 1.197 Vrms 1.254 Vrms 1.293 vRMS 1.299 Vrms
Relative Level (20Hz - 20kHz) ±0.664 dB ±0.664 dB ±0.665 dB ±0.665 dB

For some of the other results, I am going to pull in some charts that help to explain it better.

Relative level shows it is flat until the 20 kHz tone. Since most people can’t even hear this, the fall off there isn’t a large deal. The fall-off at 20Hz, which most earbuds cannot produce to a reasonable level, is much more slight and not audible. Unless you are playing back music for your puppy with the HTC One M8, this result is fine but it could be better.

THD+N is below 0.03% until just after 2 kHz when it begins a slow rise up past 0.2% at 20 kHz. This winds up being a good number but I am unsure what causes the rise in THD+N as the frequency increases.

The FFT spectrum for the 997 Hz test tone shows all artifacts below -80dB compared to the fundamental. The second and third harmonics are the largest, and those drop off by -10dB by the 4th and 5th.

This graph compares the frequency response to the BoomSound feature to having it disabled. As we saw earlier the regular frequency response is flat with a steep fall close to 20 kHz. Looking at BoomSound we see a steep roll-off below 30 Hz, a peak of almost +5dB around 60 Hz, a -5 dB section between 200 Hz and 500 Hz, and then a steep rise in the treble past 2 kHz.

Since I didn’t do the subjective listening, I would expect this to sound harsh in the treble, with the midrange being washed out by that dip in the middle. What we have is a high-end and a low-end that is +10 dB compared to the midrange. So these will sound twice as loud to you as the midrange. Using the interactive chart of music instruments by frequency you can find here, you can see what instruments this will obscure.

Comparing the THD+N ratio of BoomSound On to Off shows far more noise and distortion as well. If you want boomy bass, a harsh top-end, and no midrange, then use BoomSound. A better choice is to find headphones that suit your listening preferences more.

The HTC One M8 has good looking numbers, but putting them into better perspective requires more phone testing. As it is I see nothing that stands out as being a problem, unless you leave BoomSound on.


Smartphone Testing and Changes Samsung Galaxy S5 Audio Testing
Comments Locked


View All Comments

  • Ktracho - Tuesday, June 10, 2014 - link

    Check out the Chord's Hugo DAC/amp. It's a small device with built in rechargeable battery, but has great sound quality.
  • willis936 - Thursday, June 5, 2014 - link

    Are you using those to measure fluctuations in gravity?
  • estarkey7 - Wednesday, June 4, 2014 - link

    Why isn't there any test for High Definition Audio? This is where the difference really matters. I would love to see the true frequency range of my LG G Flex on the Sprints HD network!
  • orb242 - Wednesday, June 4, 2014 - link

    My HTC One M8 does distort certain audio at full volume... turning the volume down helps
  • cheinonen - Wednesday, June 4, 2014 - link

    I only measured the extreme distortion with BoomSound enabled at maximum volume. It also would have some clipping/distortion when using USB control, as I discussed, but the regular volume control stops before that level for me.
  • Jimster480 - Tuesday, June 10, 2014 - link

    I have only found this to be the case if using boomsound. I play it at max volume alot of the time without boomsound on and I don't seem to have an issue. I have a high end audio system in my car aswell, so I tend to notice artifacts.
  • Vishalaestro - Thursday, June 5, 2014 - link

    Still both phones doesn't even come close to the legendary Nokia n91
  • Jimster480 - Tuesday, June 10, 2014 - link

  • Cman775 - Friday, June 6, 2014 - link

    Could you test the Xperia Z2? From what I have heard from other sources it doesn't pump the same amount of power as the HTC M8. It does output a cleaner and more detailed sound signature (what sources claim).
  • Jimster480 - Tuesday, June 10, 2014 - link


Log in

Don't have an account? Sign up now